Step 1 Take lid and strainer off bottle
Step 2 Cut plastic seal that holds the lid on
Step 3 Turn tower sideways
Step 4 Place bottle in one hand
Step 5 Tilt tower 45 degrees
Step 6 Insert the bottle into the tower
Step 7 Release air bubble
There are two differnt size gaskets that are included in with your Whiskey Tower. Determine the correct size, with the lid on, and then move forward with loading your bottle. Please watch the video below with any questions on customizing your gasket to fit specialty bottles.
Step 1 Run a lace through the two bottom holes
Step 2 Zig-zag right to left up the tower
Step 3 Once you get to the top you will tie a knot
Step 4 Run the lace through the laces hiding them.
Step 5 Cut any excess lacing with a pair of sizzors
Step 1 Open valve
Step 2 Screw Handle all the way down to the bottom
Step 3 Back handle up to the proper position
Step 4 Tight valve under handle
Step 1 Make sure the tension on the handle is not loose.
Step 2 Unscrew top screw
Step 3 Tighten the valve as tight as you can
Step 4 Lower valve back to the bottom